Removing The Door Latch Assembly, The Spark Module (Dsi), And The Control Power Supply - KitchenAid KGRA806P Technical Education

REMOVING THE DOOR LATCH ASSEMBLY, THE SPARK
MODULE (DSI), AND THE CONTROL POWER SUPPLY
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug range or disconnect power.
2. Turn off gas supply to range.
3. Remove the two grates from the top of the
range.
4. Remove the control panel (see step 4 on
page 4-2 for the procedure).
Spark Module Door Latch Assy
5. To remove the door latch assembly:
a) Open the oven door and remove the
two front mounting screws from the air
vent.
Front Door Latch Screws
Ctrl Pwr Supply
4-6
b) Remove the two top screws from the
door latch assembly bracket.
Top Door Latch Screws
c) Pull the door latch assembly forward as
far as it will go, and disconnect the
wires from the terminals of the two
switches and the motor.
d) Remove the door latch assembly from
the unit.
Motor White Brown
Door Switch
(Gray & Yellow)
6. To remove the spark module (DSI):
a) Remove the bracket mounting screw.
Latch Switch
(Gray & Blue)
Bracket Mounting Screw