KitchenAid KGRA806P Technical Education page 31

7. To remove a standard gas valve:
a) Remove the ignition switch from the gas
valve you are servicing (see step 5).
b) Remove the 1/2" gas line connector
from the gas valve.
c) Remove the 1/4" hex-head gas valve
mounting screw and its rubber seal
from the front of the gas manifold.
d) Lift the gas valve off the ignition switch
mounting plate and the gas manifold.
1/2" Gas Line
Connector
Gas Valve Screw
8. To remove a TripleTier
gas valve (see the photo at the top right
column):
a) Remove the two ignition mounting plate
screws from the gas valve, and pull the
plate and switch off the valve.
b) Remove the two 1/2" gas line connec-
tors from the gas valve.
c) Remove the 1/4" hex-head gas valve
mounting screw and its rubber seal
from the front of the gas manifold.
d) Lift the TripleTier
valve off the ignition switch mounting
plate and the gas manifold.
Standard
Gas Valve

Crown Burner

Crown Burner gas
Gas Lines
Gas Valve Screw
9. To remove a thermal switch:
a) Remove the wires from the terminals.
b) Remove the mounting screws.
Control Or
Cooling Fan
Thermal Switch
REASSEMBLY NOTES:
• Before reinstalling the gas valve, make sure
that the rubber seals on the mounting screw,
and on the valve, are not cracked or dam-
aged. If they are, replace them.
• Perform a leak check on the gas valve after
reinstalling it. Use a soap bubble method to
perform the check.
Standard
Gas Valve
4-5
Ignition Switch
Mounting Plate
Screw (1 of 2)
TripleTier
Gas
Valve
Seals
