Linak TECHLINE LA33 User Manual page 74

Gear:
Plug Type:
Cable:
End Stop Signal
Output:
Feedback Level:
IC Type*:
Proportional /
Servo input:
Not used
BID:
*
A = Gear ratio 1:67
B = Gear ratio 1:39
0 = None
C = Flying leads (Signalcable with FASTIN FASTON AMP)
J = Deutsch (DT4), power 2P
K = Deutsch (DT4), power 2P + signal 4P
L = Deutsch (DT4), power 2P + signal 6P
M = Deutsch (DT4), power 2P + signal 8P
O = AMP Superseal, power 2P
P = AMP Superseal, power 2P + signal 4P
Q = AMP Superseal, power 2P + signal 6P
0 = None
1 = 1.5 m power cable
2 = 5 m power cable
3 = 1.5 m power cable and 1.5 m signal cable
4 = 5 m power cable and 5 m signal cable
5 = 1.5 m Y-cable, power and signal in one cable
0 = None
1 = Yes
2 = Controller / Hand controller
0 = None (IC w/o feedback
1 = Single Hall
2 = 0-10 V
3 = 0.5 - 4.5 V
0 = None
1 = IC Basic
2 = IC Advanced
3 = IC Proportional
0 = None
4 = 4 - 20 mA - Proportional
5 = PWM 10 - 90 % - Proportional
0 = N/A
XXX = Stroke up to 300 mm = stroke + 160 mm
XXX = Stroke from 301 mm = stroke + 210 mm
IC options: IC
LA33 actuator:
�4
4 = 4 - 20 mA)
5 = 10 - 90 %
6 = 20 - 80 %
4 = Parallel
6 = LIN bus
7 = CANbus (J1939)
8 = CANopen
Proportional LINbus
4 4
Page 74 of 80
CANbus J1939 CANopen
4 4