PowerBox Systems Competition SR2 Instruction Manual page 33

•
Learning the transmitter stick end-points
This setting is very important, and should always be carried out if you alter the
centre or end-points of the aileron, elevator or rudder gyro functions.
Follow the instructions on the screen to learn the stick end-points. Please note
that you must select the stick you wish to learn, and hold it at its end-point while
you press the SET button.
12. GYRO SETTINGS - BEFORE THE FIRST FLIGHT
It is absolutely essential to carry out Point 12 if you have installed an iGyroSAT.
You must also complete the following points before you start fine-tuning the iGyro
in flight:
- Settings in the General Settings menu
- Setup Assistant completed – installed orientation learned
- Door sequencer set up if appropriate
- All other functions assigned, including throttle, flaps etc.
- All functions set up correctly: servo centre, end-points, servo matching,
Dual Rates and Expo
The next step is to enter the iGyro menu with the cursor right at the bottom, so that
the menu jumps to the second page. There you will find the Learn transmitter stick
end-points menu point. Carry out this step as described above, in order to calibrate
all the settings which have been entered in the course of the installation procedure.
www.powerbox-systems.com 33