PowerBox Systems Competition SR2 Instruction Manual page 3

Each gyro axis can also be finely adjusted individually from the transmitter using
separate channels. If an initial test-flight shows up a need to fine-tune the iGyro to
meet individual requirements, a whole series of Expert settings cover every possible
need.
The servo matching feature is now displayed in graphic form on the screen, and the
PowerBox Competition SR2 also allows the servo response to be adjusted using
five curve points. A new development is automatic servo matching. It is a very sim-
ple matter to assign and select one or two servos in addition to the primary one,
and these two or three servos can be matched accurately to each other in just a few
seconds with a single button-press!
The Competition SR2 incorporates two independent door sequencers. The stan-
dard function is designed for a retractable undercarriage, while the second can
be used to implement systems such as a latching canopy control system without
any additional devices. The Setup Assistant is capable of setting up the first door
sequencer in just a few minutes, and three modes of operation are available. The
graphic on-screen display makes additional non-standard settings very easy to set
up; the entire sequential process can be observed at a glance.
If you use a PowerBox or Jeti RC system, virtually all* the functions of the Compe-
tition SR2 can be controlled and adjusted from the transmitter. The SR2 caters for
every aspect of telemetry for battery and receiver data with all supported systems.
If a GPS III is connected, then GPS data are also available - limited only by the faci-
lities of the RC system in use.
*except the sequencers and Setup Assistant
www.powerbox-systems.com 3