Assemble The Wing; Install The Motor Batteries - Hobbico ElectriStar EP Select Instruction Manual

Assemble the Wing

❏
1. Insert the aluminum wing joiner tube in the forward
hole in the wing root rib of the left wing half as shown.
❏
2. Join the left and right wing halves together making sure
that the alignment pin inserts into the opposite wing half.
Gently push the wing halves together. Be careful not to
crimp or otherwise damage the aileron servo wire.
❏
3. Using a small Phillips screwdriver, secure the wing
halves together by installing the two nylon straps with the
two 2.3mm x 10mm washer head screws as shown.
❏
4. Attach the unconnected pushrod to the control horn via the
clevis and slide the silicone clevis retainer in place as shown.
You may use epoxy to permanently join the wing halves
together if you wish. If you do permanently join the wing
halves, make sure that you have room to store and most
importantly, transport them to and from the field safely.
Warning: Never transport the ElectriStar EP Select with
the batteries connected. The only time the batteries
should be connected is when you are preparing the model
for flight.

INSTALL THE MOTOR BATTERIES

By now, it is likely that the motor batteries are done charging.
Let's install them.
❏
1. The battery compartment is underneath the fuse, just to
the rear of the nose wheel. Gently twist the nylon latches to
release the battery door.
8