Mounting Motor; Yamaha Security System; Digital Electronic Control Requirements - Yamaha FL350A Owner's Manual

board motor(s) does not exceed the boats
maximum horsepower rating. See the boat's
capacity plate or contact the manufacturer.
EMU33571

Mounting motor

EWM01570
WARNING
Improper mounting of the outboard mo-
●
tor could result in hazardous condi-
tions such as poor handling, loss of
control, or fire hazards.
Because the motor is very heavy, spe-
●
cial equipment and training is required
to mount it safely.
Your dealer or other person experienced in
proper rigging should mount the motor using
correct equipment and complete rigging in-
structions. For further information, see page
50.
EMU41591

Yamaha Security System

ECM02460
NOTICE
The Yamaha Security System is sold in
conformity with the relevant laws and
regulations regarding radio wave trans-
mission. Therefore, if this product is used
outside the country where it was sold, it
may violate the laws or regulations re-
garding radio wave transmission in the
country it is used in. For details, consult
your Yamaha dealer.
The outboard motor with this label is
equipped with the Yamaha Security System
to protect against theft, which consists of the
receiver and remote control transmitter. The
engine can not be started if the security sys-
tem is in the lock mode, and only be started
in the unlock mode. Consult your Yamaha
dealer for installation of the receiver.
Specifications and requirements
EMU34952
The digital electronic control be equipped
with a start-in-gear protection device(s). This
device prevents the engine from starting un-
less it is in neutral.
EWM01580
●
●
This digital electronic control unit is only
available for the outboard motor which you
have purchased.
Prior to use of the digital electronic control
unit, set it in order to operate your outboard
motor only. Otherwise, it will not be possible
to operate the outboard motor.
Perform setting of the outboard motor and
the digital electronic control unit in the follow-
ing cases.
●
●
Digital electronic control
requirements
WARNING
If the engine starts in gear, the boat can
move suddenly and unexpectedly, pos-
sibly causing a collision or throwing
passengers overboard.
If the engine ever starts in gear, the
start-in-gear protection device is not
working correctly and you should dis-
continue using the outboard. Contact
your Yamaha dealer.
If a used outboard motor is installed
If the digital electronic control unit is re-
ZMU07305
12