With Integrated Drill Drift - Optimum OPTIdrill DH 24BV Operating Manual

4.11.2 With integrated drill drift

WARNING!
Switch off the drilling machine by pushing the main switch.
ATTENTION!
The tool and/or the drill chuck
will fall down. Hold the tool or
the drill chuck firmly tight while
ejecting it.
ATTENTION!
Do not try to eject the tool in an
intermediate position. This may
result in a damage
integrated drill drift.
With the below
procedure the taper mandrel is
being loosened from the drilling
spindle.

Set the main switch (11) to "0".

Move the spindle sleeve as far downward or upward until the locking bolt (15) can be
inserted.

Move the locking bolt (15) as far as necessary until the locking bolt is completely engaged.

Press the spindle sleeve lever with a rapid and powerful movement upwards.
The taper mandrel is pressed out of the drill spindle.

GB
DH34BV | DH40BV
44
of the
described
Img.4-11: Disassembly with integrated drill drift
Originalbetriebsanleitung
11
15
8
Version 1.1.3 - 2020-0723