Stopping The Circulator; Power Down; Shut Down; Restarting - Thermo Scientific ADVANCED Series Quick Start Manuals

Section 4 Operation
Stopping the
Circulator

Power Down

Shut Down

CAUTION
CAUTION
CAUTION

Restarting

4-4
Ensure the stop symbol is highlighted, if not use the arrow keys to
navigate to the symbol.
Press . The circulator stops and the stop symbol turns into a start
symbol ( ).
Stop Symbol
Press , the display goes blank and the circulator enters the stand by
mode. The blue LED illuminates.
Place the circuit protector on the back of the circulator to
the O position. The blue LED extinguishes.
On refrigerated baths, place the circuit protector on the rear of the bath
to the O position.
Using any other means to shut down a refrigerated bath can re-
duce the life of the compressor.
Always turn the circulator off and disconnect it from its supply
voltage before moving it.
The circuit protector located on the rear of the components is not
intended to act as a disconnecting means.
Note When quickly restarting, the compressor may take up to 10
minutes before it starts to operate.
SP1
20.0°C




Menu
In
24.2°C
I
O
Thermo Scientific