Configuring Parameter Sets; Setting Menu A Parameters - Leica CV5030 Operating Manual

5. Operation
The configuration menu
Press 1 x
32
(continued)
Fig. 32
73
Fig. 33

5.4.1 Configuring parameter SETs

There are a total of four parameter sets (SET 1 to
SET 4) that can be stored in the instrument.
Pressing the START button calls up the respec-
tive next (higher) parameter set.
Pressing the Pause button calls up the respec-
tive next (lower) parameter set

5.4.2 Setting menu A parameters

To modify the individual parameters, you first
have to press the button in the second line below
the respective parameter.
Example:
To modify the stroke length (STK) of the coverslip-
ping mountant, press the RELEASE COVERSLIP
button (Fig. 33).
The corresponding menu appears in
the display. The left-hand side of the
top line specifies the parameter set
to which the value is assigned.
The value (73) can be modified in a
way similar to that shown in
(Fig. 33) using the buttons START (in-
creases the value by one increment)
and Pause (decreases the value by
one increment).
Operating Manual V 2.1 – 08/2008
(Fig. 32).