Input Settings - RGBlink X3 User Manual

Default 2D-Mode, right click the signal, and select "Set Input 3D Type", it will enter the
interface as follows:
User can select "3D-Mode One InputSource" or "3D-Mode Two InputSource". If select
"3D-Mode One InputSource", it will show "3D" on the signal, as shown in the figure below:
If select "3D-Mode Two InputSource", it will show "3D-1" and "3D-2" on the signal, as
shown in the figure below:
The other operations are same with "Videowall Mode".

3.2.5 Input Settings

Click the "Input Settings", and enter the interface as follows:
X3 User Manual
43