Data Connection To The Pc; Ecom-Das Nt2 - Ecom ST Operating Instructions Manual

7.2 Data connection to the PC

If the device is connected to a PC, measured values can be recorded with
PC software from ecom.
The following software solutions are available:
• ecom-DAS NT 2
• ecom-DAS 5

7.2.1 ecom-DAS NT2

In addition to the data logger recording, the data can also be transferred
directly to the PC software "ecom-DAS NT 2" while the measuring operation
is running.
The USB interfaces can be used for communication with the software. The
transmission speed and the protocol are predefined for smooth
communication between the device and the DAS NT 2 PC software via the
USB interface.
To enable communication with the DAS NT 2 PC software, the following
settings must be made in the Settings / Internal / USB menu:
Parameter
Transfer speed
Protocol
NOTE
A driver is required for the communication between the device and
the DAS NT 2 PC software via the USB interface.
Download under:
ecom-ST 1.0
Adjustment field
1200 Baud − 115200 Baud 1200 Baud
DAS = DAS NT 2
Enhanced = DAS 5
---- = none
https://www.ecom.de/kundendienst/downloads/
Adjustment for DAS NT 2
DAS
37