Starting Up; Measurement Procedure; Preparation - Ecom ST Operating Instructions Manual

3. Starting Up

1. Connect the gas sampling system to the device.
2. Connect the gas sampling system to the extraction point.
3. Connect the power supply unit.
4. If necessary, connect hose for fresh air supply (AIR-IN Gas
processing module).
5. Connect hose for condensate evacuation disposal.
6. Switch on the device.

4. Measurement Procedure

4.1 Preparation

NOTE
Prior to each measurement, make sure that:
•
the device has no visible defects.
•
the measuring system is tight.
Gas analysis
Settings
Control
Remote setup
Menu point
Gas analysis
Settings
Control
Remote Setup
ecom-ST 1.0
After switching on the device, the start screen
is shown on the display and then the main
menu. In the main menu 4 submenus are
displayed.
Meaning
Perform flue gas analysis
Modify instrument settings
Check operation state of instrument
Adjust data transfer
21