Table of Contents
Advertisement
12 Disposal
Observe the following points when disposing of the SYEPS punching system:
1.
Drain the punching system completely.
2.
Dispose of the hydraulic fluid in accordance with the national regulations of your
country and in accordance with the safety data sheet for the hydraulic fluid.
3.
Dismantle the punching system for recycling.
4.
Separate by:
– Cast iron
– Steel
– Non-ferrous metals
– Electrical waste
– Plastics
– Seals
12.1 Environmental protection
Careless disposal of the SYEPS punching system, the hydraulic fluid and the
packaging material could lead to pollution of the environment.
▶
Therefore, dispose of the SYEPS punching system, the hydraulic fluid and the
packaging material in accordance with the currently applicable regulations in your
country.
▶
Dispose of hydraulic fluid residues according to the applicable safety data sheets
for these hydraulic fluids.
13 Extension and conversion
The SYEPS punching system may only be converted or extended in the case
described below using genuine Rexroth SYEPS components. Other conversions
or extensions, also the readjustment of lead-sealed adjustment potentiometers,
render the warranty void. The replacement of a component with a component of the
identical design is described in Chapter 11.5 "Replacing components" on page 116.
The punching system SYEPS can be extended with HM16 pressure sensors for
monitoring system pressures and the adaptive soft punch function.
RE 30201-B/07.2014, SYEPS series 1X, Bosch Rexroth AG
Disposal 121/132
Advertisement
Table of Contents
