Receiving In Auto Mode; Receiving Automatically In Ans/Fax Mode - Muratec F-110 Operating Instructions Manual

Receiving in AUTO Mode

1. Press and hold down RECEIVE MODE/CONTRAST on the front panel
2. When you get a call, the machine answers it.

Receiving Automatically in ANS/FAX Mode

For this mode, you MUST attach an answering machine to the EXT. jack
on the back of your machine (see
1. Press and hold down RECEIVE MODE/CONTRAST on the front panel
2. When you receive a call, the answering machine will answer.
Notes:
• If you have set your machine to ANS/FAX mode and your answering
• If your answering machine has a 'user-selectable ring counter', set the
• If you are in TEL mode (manual reception) when the answering
3.16
Stand-alone Fax
All manuals and user guides at all-guides.com
repeatedly until the display shows 'AUTO MODE'.
If a fax is being sent, the machine goes into reception mode.
If the machine does not detect a fax signal, it will continue ringing to
tell you it is a phone call. You should pick up the handset to answer
the call, or it will switch to automatic reception mode.
repeatedly until the display shows 'ANS/FAX MODE'.
If the caller leaves a message, the answering machine stores the
message as it would normally. If your machine hears a fax tone on
the line, it automatically starts to receive fax.
machine is switched off, or no answering machine is connected to your
machine, your machine will automatically go into FAX mode after 6 rings.
machine to answer incoming calls within 1 ring.
machine is connected to your machine, you must switch off the
answering machine, or the outgoing message from the answering
machine will interrupt your phone conversation.
page A.1).