General Printing Problems - Muratec F-110 Operating Instructions Manual

General Printing Problems

Problem
Your machine does not
print.
The paper is not feeding
into the machine.
The paper keeps jamming.
All manuals and user guides at all-guides.com
Possible Cause and Remedy
• A paper jam has occurred. Remove the jammed paper.
See page 6.1.
• The toner cartridge is not installed properly. Remove and
reinsert the toner cartridge.
• The printer cable is not connected properly. Check the
printer cable connection.
• The printer cable is defective. Swap the cable with one
known to work.
• The port setting is incorrect. Check the Windows printer
settings to make sure that the print job is being sent to
the correct port (for example, LPT1).
• The printer properties may be configured incorrectly.
Check the application to make sure that all print settings
are correct.
• The printer driver may be incorrectly installed. Uninstall
the MFP driver and reinstall the MFP driver. Then try
printing a test page.
• Paper has not been inserted correctly. Remove and
reinsert the paper correctly. See 'Using Automatic Paper
Input Tray' on
on page 4.5.
• There is too much paper in the paper input tray.
Remove some of the paper from the input tray.
• There is too much paper in the paper input tray. Remove
some of the paper from the tray. (If printing onto
envelopes or labels, insert them one at a time in the
manual paper input tray.)
• The paper setting method may be incorrect. If printing
onto envelopes, insert the envelopes so that there is a gap
of approximately 1 mm (1/32") between the left and right
edge of the envelopes at the paper guide.
page 4.3 or 'Using Manual Paper Input Tray'
6.9
Troubleshooting