Cleaning The Opc Drum; Adjusting Shading - Muratec F-110 Operating Instructions Manual

Cleaning the OPC Drum

If you are getting streaks or spots on your print, you may need to clean
the OPC drum.
1. Make sure that the paper is loaded in the automatic input tray.
2. Press SET UP on the front panel.
3. Press ➛¤or ❿ until 'MAINTENANCE' appears, then press
4. The display will show the first menu, 'CLEAN DRUM', press
5. Press STOP to return to Standby mode.

Adjusting Shading

If the scanning unit becomes dirty, it can alter the shading value. If your
print has black lines or it is blurred, adjust the shading setting. Take the
following steps:
1. Load a sheet of white paper into the document feeder.
2. Press SET UP on the front panel.
3. Press ➛ or ❿ until 'MAINTENANCE' appears, then press
4. Press ➛ or ❿ until you find 'ADJUST SHADING', then press
5.2
Maintenance
All manuals and user guides at all-guides.com
The display shows the first setup menu; FAX NUMBER/NAME.
START/ENTER.
START/ENTER.
The machine automatically pulls in a sheet of paper, and prints it out.
The toner particles on the OPC drum surface are fixed to the paper.
The display will show the first setup menu; FAX NUMBER/NAME.
START/ENTER. The display will show the first menu; CLEAN DRUM.
START/ENTER.
The white paper is scanned through the document feeder.