Autoslide iLock Installation Manual page 25

PAIRING WIRELESS WALL BUTTONS AND WIRELESS SENSORS
1. Remove both wireless wall-mounted push
buttons from the box and remove the plastic tab
battery protector from both buttons.
2. Press each wall button to ensure it flashes blue
when pressed. If the door opens when the wall
button is pressed, the button is already paired
and can be set aside.
3. To pair a button to the AutoSlide, press and
release the "Sensor Learn" button on the
AutoSlide control panel. A red light should
illuminate next to the button once released.
4. Press the wall button once. The red light should
blink three times. Press the wall button again.
The red light should go out. This indicates the
AutoSide has learned the wall button
5. Test the wall button by pressing it to open the
door.
The same process is used to pair any wireless sensor/remote to the AutoSlide system:
1. Press and release the Sensor Learn button once.
2. Trigger the wireless sensor/remote once.
3. Trigger the wireless sensor/remote again.
4. Test the sensor/remote to ensure it's paired to the system.