Autoslide iLock Installation Manual page 23

PROGRAMMING STACKER OPENING WIDTH
4) From Green Mode, press the mode button
(circled at right) one time to place the unit
into Blue (Stacker) Mode. The door may
open automatically to a partial factory
width.
To start the programming process,
reverse DIP switch #1 from its current
position then immediately reverse back
DIP switch #1 (flip it back and forth).
- The door will immediately open until it
hits an open jamb or doorstop. If none
exist, manually pull the door when it
reaches the desired full opening width to
keep it from opening any further.
Once the stacker programming process is
started, the door will:
1. open fully, then
2. close fully.
Once the door is staying in the fully closed
position with a solid Blue mode light, the
stacker opening width is programmed.
To test the door, press the Mode button
repeatedly until the unit is in Green Mode. Once
the door is in Green Mode and staying closed,
press the Mode button one time to place the door
into Blue Mode. The door should automatically
open to the programmed Stacker width.