Autoslide iLock Installation Manual page 14

DRIVE MOUNTING
1)
o The bottom of the motor wheel should reach
below the bottom edge of the door frame, so that
the motor wheel can meet the track once
mounted.
o If the motor wheel doesn't reach below the
edge of the door frame, there will be a vertical
gap between the wheel and track. In this case,
the unit will need to be shimmed down.
Note: If the top header doesn't have enough width to
mount the system, the adapter bracket can facilitate a
direct wall mount (as shown). Note the unit can be
adjusted both vertically and horizontally with the bracket.
This adapter bracket can also be used as reinforcement,
and can be mounted either flange up or flange down.
WALL
Mounting adapter (green) used
flange up, drill mounted to wall
ADAPTER
BRACKET
Door frame
Motor wheel
must reach below
door frame
Mounting adapter (green) used flange
down, drill mounted to door frame; do not
drill into the rail for the sliding panel itself
ADAPTER
BRACKET
13
hh