Autoslide iLock Installation Manual page 21

POWERING ON AND INITIALIZING
Manually move the door to halfway
2)
between open and closed. Use the red
power switch to power the unit on:
- If the unit starts to close the door,
let the door close completely before
proceeding to the next step.
- If the unit starts to open the door,
power off the unit. Turn DIP switch
#1 ON, then power on the unit (see
right figure). The door should now
start to close.
The door should close until it hits a jamb
or doorstop. Once it closes and stays
closed...
- If the unit has a solid Green mode light
on the front, proceed to the next step.
- If the unit has a solid Red, Blue, or
Yellow mode light, locate the Mode
Button (gray button with a blue star,
circled to right). Press this button
repeatedly to toggle through modes until
the Green Mode light is selected.