Paper Feed; Tray Feed - Brother HL-2700CN series User Manual

Paper feed

Tray feed

The printer can feed paper from the standard paper tray, optional lower tray or optional legal tray.
When you put paper into the paper tray, note the following:
If your application software supports paper size selection on the print menu, you can select it
through the software. If your application software does not support it, you can set the paper size
in the printer driver or by using the control panel buttons.
The paper size has been set at the factory to Letter for 120 V models or A4 for 220/240 V
models. If you want to use other sizes of paper or envelopes, change the paper size setting in
PAGE FORMAT in the FORMAT menu by using the control panel buttons. For paper size
selection, see PRINT MENU on page 3-13.
If you use pre-printed paper in the trays, please be sure to put the paper with the printed side
face up and the top edge of the paper at the back of the paper tray.
The printer automatically detects the paper size you have put into the paper tray. The printer will prompt
you to put the correct size of paper in the tray as follows:
If you want to put a different size of paper into the paper tray from the size that was selected in the paper
size setting by using the control panel buttons or in your application software, you can change the paper
size setting.
Print on envelopes
Adjust the paper length and width guides to fit the envelopes that are going to be used.
SIZE MISMATCH
Put <size> paper size in Tray
<1/2>. Paper mismatch between
the Printer and the Printer
Driver setting
Figure 1-13
ABOUT THIS PRINTER 1 - 18