VETRON 5374 Service Manual page 45

DESCRIPTION
To choose from: OFF | HEAT | WELDING SPEED | GAP MEASUREMENT| PRESSURE
Time before break get active
Di erential speed between the upper and lower wheel
Diameter of the lower wheel
Number of teeth of the gear wheel Z1
Number of teeth of the gear wheel Z2
Diameter of the upper wheel
Wheel diameter of the tape feed (Di erential speed of the tape feed possible)
Number of teeth of the gear from the tape drive
Number of teeth of the gear from the tape drive
Airflow hight of the upper wheel
Please don't change!
Values are determined when the machine is started up.
The calibration transfers these into the basic parameters.
Wheel diameter
Time how long temperature is pending on (for faster cycle times)
Tape pulls back after the cut
Minimum air flow of the nozzle
02/2021
Vetron 5374 HotAir-Welding
43