Brother MFC-3100C Owner's Manual page 193

6
Hold the new ink
cartridge as shown in
the illustration, and
then peel the sealing
tape from the side of
the ink cartridge.
Carefully peel the tape
in the direction away
from you.
To prevent spilling ink and staining your hands and clothing, remove the
Note
sealing tape gently.
7
Each color has its own correct position. Insert each new ink cartridge into the
carriage.
8
After installing the ink cartridges, close the top cover and control panel cover.
Your MFC prepares for a "head cleaning" and goes online. The LCD prompts
you to verify a new ink cartridge was inserted for each color you removed.
Example: DID YOU CHANGE BLCK? 1. YES 2.
If the ink cartridge you installed is not a brand new one, please make sure to
select 2.
9
For each new cartridge, press 1 on the dial pad to reset the ink dot counter for
that color automatically. (The ink dot counter enables the MFC to notify you
when a color is running low.)
The MFC will enter a cleaning cycle for approximately 3 minutes for each
replaced cartridge. The LCD alternately shows
WAIT.
When the MFC completes the cleaning cycle, the LCD returns to Standby mode
(date and time).
WARNING
If ink gets in your eyes, irrigate them with water immediately and consult a
doctor if you are concerned.
T R O U B L E S H O O T I N G A N D R O U T I N E M A I N T E N A N C E
Peel in the direction
away from you!
Opening
NO.
CLEANING and PLEASE
20 - 18