Remote Commands - Brother MFC-3100C Owner's Manual

Remote Commands

Follow the commands below to access features remotely. When you call the
MFC and enter your Remote Retrieval Access Code (1 5 9
signal you with two short beeps to enter a remote command.
Remote Commands
95 Change Fax Forwarding
/Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON
7 Fax Storage OFF
96 Retrieve a fax
2 Retrieve all faxes
3 Erase fax from the memory
97 Check the Receiving Status
1 FAX
98 Change Receive Mode
1 EXT.TEL/TAD
2 FAX ONLY
90 Exit
9 - 4
R E M O T E F A X O P T I O N S ( N O T A V A I L A B L E F O R C O L O R F A X )
Operation Details
If you hear one long beep, the change is accepted. If you hear three
short beeps, you cannot change it because the conditions have not
been met (Example: registering paging number). You can register
your fax forwarding number by using 4. FAX FWD NO. (see page
9-5). Once you have registered the number, the MFC will change
automatically to FAX FWD:ON mode.
You can turn FAX STORAGE to ON or OFF.
Enter the number of a remote fax machine to receive stored fax
message(s). (See page 9-5.)
If you hear one long beep, you can erase fax message(s) from the
memory.
You can check whether your MFC has received any faxes . If yes,
you will hear one long beep. If no, you will hear three short beeps.
If you hear one long beep, you can change the Receive Mode.
If you hear three short beeps, you cannot change it.
After a long beep, you can exit remote retrieval.
), the system will