Table of Contents
Advertisement
2.4
Battery Operation
The 482-AG can be equipped with an optional internal Lithium-Ion battery to provide up to:
• 40 hours of continuous use (single load cell, 350 ohms, no LCD backlight)
• 15 hours of continuous use (single load cell, 350 ohms, with LCD backlight)
When operated on AC power, the internal battery is automatically charged.
The status of the battery is displayed by an icon in the upper left corner of the LCD display. When operating on battery power,
the icon of the approximate percentage of battery life remaining displays. When connected to AC power, the icon indicates if the
battery is charging or fully charged. The following table outlines the meaning of the various battery icon indication levels.
Battery life depends on several factors, including number of load cells, frequency of use, LCD backlight, options installed,
temperature, and other accessories being used. Battery charge time is approximately 16 hours to 100%.
To extend battery life, the indicator features a sleep mode that allows the indicator to go into a low power mode while it's
operating on battery power, see
When the battery life reaches 5-10 percent of capacity, the Lo Bat flashes on the display. When the battery life is less than 5%,
it will flash faster. At 0% the indicator will turn off. Battery charge time is approximately 16 hours to 100%.
When installing a 482-AG with a battery option, it is recommended that the CPU board jumper 4 on the A/D Board be
Note
removed. See
Figure 2-6 on page
turned off due to reduced standby current, see the POWER parameter in
information.
2.5
Configurable Back Light
The 482-AG includes a configurable LCD backlight for viewing the display in low-light situations. The backlight can be
configured to be On, Off or in Auto Mode. Configure the backlight using the BKLGHT parameter, see
page
35. When using battery power, use the off or automatic setting to reserve power.
The backlight consumes considerable power. When the automatic setting is selected, the backlight will go out after a set time of
inactivity. Pressing a key or any motion on the scale will activate the backlight.
The backlight is configured using the BKLGHT menu function. To set Auto Mode, select one of the fixed time settings between
10 seconds and 10 minutes. The backlight will turn off when there has been no change of motion or key presses during the
selected time. The backlight will turn back on automatically once there is a change in motion or a key pressed.
Battery Percent
100% > bat > 75% 4 - Levels
75% > bat > 50% 3 - Levels
50% > bat > 25% 2 - Levels
25% > bat > 10% 1 - Levels
10% > bat > 5%
0 - Levels
5% > bat > 0%
Blinking
0%
Indicator is turned off
Charging
Animated
Table 2-1. Battery Indication Levels
Section 3.3.1 on page 25
for more information about the sleep mode.
Figure 2-7. Battery Charging Cycle Example
10. Removing jumper 4 will maximize the life of the battery when the indicator is
Battery Indicator Level
Section 3.6.6 on page 35
© Rice Lake Weighing Systems ● All Rights Reserved
Installation
for more
Section 3.6.6 on
11
Advertisement
Table of Contents
