Brother FAX-2820 User Manual page 98

DIFFICULTY
Scanning Difficulties (MFC-7220 and MFC-7225N only)
TWAIN errors appear while
scanning.
Software Difficulties (MFC-7220 and MFC-7225N only)
Cannot install software or print.
Cannot perform '2 in 1' or '4 in 1'
printing.
Machine does not print from Adobe
Illustrator
When using ATM fonts, some
characters are missing or some
characters are printed in their
place.
'Unable to write to LPT1' or 'LPT1
already in use' Error Message
appears.
'MFC is Busy' Error Message
appears.
Paper Handling Difficulties
The machine does not feed paper.
The LCD shows No Paper Fed or
Paper Jam.
The machine does not feed paper
from the manual feed slot.
How can I load envelopes?
What paper can I use?
How can I clear paper jams?
SUGGESTIONS
Make sure the Brother TWAIN driver is selected as the primary source. In
®
PaperPort , click Scan in the File menu and select the Brother TWAIN driver.
Run the Repair MFL-Pro Suite program on the CD-ROM. This program will repair
and reinstall the software.
Check that the paper size setting in the application and in the printer driver are the
same.
Try to reduce the print resolution. (See Advanced tab in the Software User's Guide
on the CD-ROM.)
®
If you are using Windows 98/98SE/Me, select 'Printer Settings' from the 'Start'
menu. Select the properties of the 'Brother MFC-7220 or MFC-7225N'. Click
'Spool Setting' on the 'Details' tab. Select 'RAW' from 'Spool Data Format.'
1.Make sure the machine is on (plugged into the electrical socket and the power
switch turned on) and that it is connected directly to the computer using the
IEEE-1284 bi-directional parallel cable. The cable must not go through another
peripheral device (such as a Zip Drive, External CD-ROM Drive, or Switch box).
2.Make sure the machine is not displaying an error message on the LCD Display.
3.Make sure no other device drivers, which also communicate through the parallel
port, are running automatically when you boot up the computer (such as, drivers
for Zip Drives, External CD-ROM Drive, etc.) Suggested areas to check: (Load=,
Run=command lines in the win.ini file or the Setup Group)
4.Check with your computer manufacturer to confirm that the computer's parallel
port settings in the BIOS are set to support a bi-directional machine; i.e. (Parallel
Port Mode – ECP)
If there is no paper, load a new stack of paper into the paper tray. If there is paper
in the paper tray, make sure it is straight. If the paper is curled, you should
straighten it. Sometimes it is helpful to remove the paper, turn the stack over and
put it back into the paper tray. Reduce the amount of paper in the paper tray, and
then try again. Check that the manual feed mode is not selected in the printer
driver.
If the LCD shows Paper Jam and you still have a problem, see Paper jams on
page 11-6.
Reinsert the paper firmly, load one sheet at a time. Make sure that manual feed
mode is selected in the printer driver.
You can load envelopes from the manual feed slot. Your application software must
be set up to print the envelope size you are using. This is usually done in the Page
Setup or Document Setup menu of your software. You should refer to the manual
provided with your software application.
You can use plain paper, recycled paper, envelopes, transparencies and labels
that are made for laser machines. (For information on paper you can use, see
About paper on page 1-8.)
See Paper jams on page 11-6.
Troubleshooting and routine maintenance
11
11 - 13