Table of Contents
Advertisement
The gain will be listed under each bar. Tap on a colored bar to adjust the
settings. Tap the + or – button to increase or decrease the gain of that
electrode.
You may also choose to turn off the electrode. After tapping the colored bar,
click the "Turn Off" button if the electrode is on. If the electrode is already off,
you may turn it on after tapping that electrode's location in the bar graph;
gains cannot be adjusted unless the electrode is on. If an electrode is turned
off, it will be noted under its respective bar.
If settings are modified, the new setting is sent automatically to the
Sense Controller, and the changes are immediately reflected in the signal
viewer. However, to save these changes permanently, you must press the
"Recalibrate" button, which becomes red after any gain is adjusted.
Tap "Recalibrate" to be taken to the Calibration Setup page, or tap Revert to
revert back to the previous settings.
60
Impedance
and
Disconnection
Warnings
The low impedance icon
under
a
channel
indicates
that
corresponding electrode is having
difficulty acquiring a consistent EMG
signal on that area of skin. Ensure
that each individual bar on that
electrode is maintaining contact
with the skin during the full range of
motion of the residual limb.
The disconnect icon
under a
channel indicates that the Sense
controller has lost communication
with that electrode.
Ensure that
the connector for the electrode is
seated all the way and that there is
no damage to the cabling.
Movements Popup
On the signals page, tapping the
information icon
pops up a
window showing the movements
you have calibrated, along with the
time of last calibration.
the
61
Advertisement
Table of Contents
