Infinite sense Installation And Setup Manual page 23

Movements
The movement options listed here are related to the configuration of the
device.
The options that are selected here will be part of the pattern recognition
algorithm after calibrating. At least one movement must be selected at any
given time. There are different indicators for movement selection and they
are described below:
Gray only
If a movement button is completely gray, then the movement is not selected
to be part of the next calibration process. This movement will not be part of
the Sense controller classifier.
Black outline
If a movement button is outlined in black, this means it is selected to be
calibrated in the next calibration process. However, these movements have
not yet been calibrated.
44
Red outline
If a movement button is outlined in red, this means that it is selected to be
calibrated in the next calibration process. These movements have not been
calibrated in all positions. See the section below on Positions.
Red fill
If a movement button is filled in red, this means that it is selected to be
calibrated in the next calibration process and the calibration is up to date. No
changes need to be made if you do not wish to recalibrate.
Note 1: If the positions selected change, the color indicators on the movement
buttons may change as well.
Note 2: If you switch the Microsoft Surface that the software is used on, the
color indicators may change. The calibration data is not saved on the Sense
Controller, only on the Microsoft Surface.
Positions
Multi-positional calibration improves the consistency of pattern recognition
in a wider range of the arm workspace. For example, muscle signals will
appear differently whether the arm is in front of the body, or raised above it.
The patient will calibrate all the movements selected in each arm position
sequentially, and the data will be aggregated afterwards into a single control.
Up to 5 different positions may be selected at once. At least one position
must be selected at any given time.
45