Table of Contents
Advertisement
Configuring the device
Your device will be pre-configured based on the order. If your patient travels
to other countries, you may need to change the region to avoid noise
introduced by powerlines. (US - 60Hz, EU - 50Hz). Click the gear button at
the top left corner of the page. The configuration page lists the settings on
the device, these settings should reflect the properties of the terminal device
being controlled by the Sense system.
Pause outputs to the prosthesis
In the top left corner of the GUI, there is a pause button. When selected
once, this option pauses outputs to the prosthesis. When selected again,
the prosthesis outputs resume. This button is activated automatically when
calibrating or using the virtual arm.
Open/Close Mode
The Open/Close Mode is located to the right of the Pause Prosthesis button
- click "Open/Close Mode On" to turn on the mode. When this mode is active,
all calibrated grip movements except Open will close the hand in the grip
last used before the "Open/Close Mode On" button was pressed. The only
exception is the Open movement, which will open the hand in that grip. In
order to change grips, you can use the buttons on the back of the hand or
an App that comes with the hand. Press "Open/Close Mode Off" to exit the
mode.
56
sense app
7
CONNECTING SENSE TO THE APP
Introduction to Calibration
Search for "Sense IBT" in the Play Store or Apple Store, and install the version
that is compatible with the software on the controller. That information will
be printed on the Sense Controller box.
Ensure Bluetooth is enabled on your smart device.
To perform once: Power on the Sense controller (see Powering Sense with
FlexCell). Wait ten seconds, and within your smart device's Bluetooth pairing
menu, search for the Sense controller's device ID that is printed on the Sense
controller box (follows the format IBTCoreXXXXXX). Pair the device.
Launch "Sense" on your smart device
If your smart device is pairing with a
Sense controller for the first time, you
will be taken to the Welcome menu
showing Sense controllers you can
connect to. Select the Sense device
ID you paired with in the previous step.
Tap on "Scan" if you cannot find the
device ID.
Note: For subsequent uses with the
same Sense device, you will not need
to repeat this step. You will only need
to repeat this step if (1) if you're using
a different Sense system (i.e. for a
different patient); (2) you switch to
another smart device.
57
Advertisement
Table of Contents
