Infinite sense Installation And Setup Manual page 12

Note: If a suction socket is being created, completely sealing the electrode
cable exit helps maintain consistent suction. The cable exit can be sealed
with the provided silicone adhesive. To seal the cable exit with silicone
adhesive, apply a dime-sized amount of it to the back of the electrode and
about 5mm up the cable protruding from the electrode. Do this before
snapping the electrode into the pocket. Wait 15-20 minutes for this to dry
before testing suction.
ELECTRODE WIRE
SOCKET
TOLERANCE GAP
ELECTRODE
NOT TO SCALE
OPTIONAL TO ADD
OUTSIDE SOCKET
SILICONE ADHESIVE
22
Outer Frame
Do not mold the outer frame directly around the inner socket. Leave 3mm
(around the thickness of a 3-ply sock) between the inner socket and frame
to ease assembly and avoid cable damage. Use the dummy for the Sense
controller provided with the system to make sure there is sufficient space in
the prosthesis. Otherwise, create the outer frame using standard fabrication
techniques.
Note: Place the Sense box near the distal end of the prosthesis for best
Bluetooth performance.
FRAME
SOCKET
ELECTRODE
The socket harness or suction mechanism must be well
constructed to prevent electrode slip and the need for constant
recalibration.
MIN. 3MM GAP
SENSE CONTROLLER
23