Table of Contents
Advertisement
5 - E2 Elbow
1. Route cables for hand input, hand power and wrist input through the
forearm.
2. Use connections as shown in the previous sections depending on wrist
and terminal device components.
3. Connect Sense to E2 elbow as shown below
6 - U3+ Elbow
1. Unplug the provided 21-pin block connector from the elbow.
2. Plug the 21-pin block connector attached to Sense into the elbow
DEFAULT CABLE
FROM SENSE
FROM SENSE
32
7 - Boston TMR Elbow
1. Push the 3 square connectors through the diaphragm of the electrode
input board
2. Plug the 3 connectors as shown into their respective connectors – red
stripe to MY1, black stripe to MY2, silver stripe to A34
A34
MY1
MY2
33
Advertisement
Table of Contents
