Table of Contents
Advertisement
Device Management
This section describes how to connect to and manage the device.
3.1
Connecting a RUGGEDCOM WIN Subscriber Station
The RUGGEDCOM RP110 is designed to be a Power-over-Ethernet (POE) injector for
RUGGEDCOM WIN5000 series subscriber stations.
IMPORTANT
If the RUGGEDCOM RP110 is to be installed outdoors, make sure the connection
between both devices is bridged by a suitably rated lightening protector. For more
information, refer to
To connect a RUGGEDCOM WIN subscriber station to the device, do the following:
•
3.2
Configuring the Device
Configuration of the device is done via the RS-232 serial terminal, which provides
access to the boot-time control and RUGGEDCOM ROS console interface. The serial
terminal implements RS-232 DCE (Data Communication Equipment) on a Phoenix-
style compression connector.
IMPORTANT
Make sure a RUGGEDCOM WIN5000 series subscriber station is connected to the
RUGGEDCOM RP110 before configuring the device. For more information, refer to
"Connecting a RUGGEDCOM WIN Subscriber Station (Page
For more information about the boot-time control and RUGGEDCOM ROS console
interface, refer to RUGGEDCOM ROS Configuration Manual for the RUGGEDCOM
RP110.
RUGGEDCOM RP110
Installation Manual, 01/2021, C79000-G8976-1012-04
"Installing the Device Outdoors (Page
Connect a CAT-5e cable between the ETH/PWR port on the subscriber station
and the 10/100Base-TX PoE port on the RUGGEDCOM RP110.
6)".
13)".
3
13
Advertisement
Table of Contents
