Required Tools And Materials - Siemens RUGGEDCOM RP110 Installation Manual

1
2
3
4
5
6
7
8
9
10
11
Figure 1.1
Port Status LEDs
ALARM LED
POWER LED
RS232/RS422/RS485 Serial
Terminal
Communication Ports
Power Supply Terminal Block
Chassis Ground Terminal
1.3

Required Tools and Materials

The following tools and materials are required to install the RUGGEDCOM RP110:
AC or DC power cord (16 AWG)
RUGGEDCOM RP110
Installation Manual, 01/2021, C79000-G8976-1012-04
Lk LED
Act LED
Tx LED
Rx LED
ALARM LED
Serial BNC Port
RS232/RS422/RS485 Serial Terminal
Power Terminal Block
POWER LED
Copper Ethernet Port
Chassis Ground Terminal
RUGGEDCOM RP110
Tools/Materials
Indicates the connection status of the communication ports.
LED
Lk Green
Act Green
Tx Green (Blinking)
Rx Green (Blinking)
Illuminates when an alarm condition exists.
Illuminates when power is being supplied to the device.
The RS232/RS422/RS485 serial terminal serves a dual purpose:
• The RS232 terminals allow for a direct interface with the device
and access to initial management functions. For information
about connecting to the device via the serial terminal, refer to
"Configuring the Device (Page
• The RS422/RS485 terminals allow for half or full duplex serial
connections respectively. For more information, refer to
"Communication Ports (Page
Receive and transmit data. For more information about the
various ports available for the RUGGEDCOM RP110, refer to
"Communication Ports (Page
A pluggable terminal block. For more information, refer to
"Connecting Power (Page 9)"
(Page 23)"
Protects the device from power surges and accumulated static
electricity. For information about grounding the device, refer to
"Grounding the Device (Page
For connecting power to the device.
Introduction
1.3 Required Tools and Materials
State Description
Link is established
Activity on copper
Ethernet port
Serial port is
transmitting
Serial port is
receiving
13)".
15)".
15)".
and "Power Supply Specifications
8)".
Purpose
3