Table of Contents
Advertisement
1. Connect using Hyperterminal @ 9600, 8, N, 1.
2. Hit enter (you won't be able to see this text), the NetGuardian will respond with "Password."
Note: If you receive no password prompt then check the port you are using on your PC and make sure
you are using a straight thru cable.
3. Type the default password, "dpstelecom," then press Enter.
Note: DPS strongly recommends changing the default password.
4. The NetGuardian's main menu will appear.
5. Type C for the C)onfig menu.
6. Type E for E)dit menu.
7. Type E for port settings, N for Net.
8. Configure the unit address, subnet mask, and default gateway.
9. ESC to the main menu.
10. When asked if you would like to save changes, type Y (yes).
Configure the Ethernet port parameters
27
Advertisement
Table of Contents
Need help?
Do you have a question about the NetGuardian 420 and is the answer not in the manual?
Questions and answers