Reboot; Run Config; Contrast - DPS Telecom NetGuardian 420 Hardware User Manual

19
Sound off
The Sound off command suppresses sounds from the alarm speaker for a user-defined period of 10, 20, or 30
minutes. To scroll to the next menu command, press the q button.
To change the Sound off setting, press Sel to select the command. The arrow cursor (>) will move to the right
of the colon (:) in Sound off: to indicate that the command submenu is selected. Press the q and p buttons to
scroll through the Sound off time period options. Select 0 minutes to allow all sounds. When the time period you
want is displayed, press Sel to make your selection. To exit the Command Menu without changing the Sound
off setting, press Menu.

6.2.2 Reboot

Reboot command
Reboot
The Reboot command reboots the NetGuardian. Press Sel. The LCD will briefly display the message
Rebooting ..., and the normal boot sequence will begin. To exit the Command Menu without rebooting,
press Menu.

6.2.3 Run Config

Run Config command
Run Config
The Run Config command forces the TTY configuration interface to run over the craft port at the user defined
baud rate (default is 9600 baud).
To run the TTY configuration utility, press Sel. To exit the Command Menu without running the TTY
interface, press Menu.

6.2.4 Contrast

Contrast command
Contrast
The Contrast command provides controls for adjusting the contrast of the LCD.
To adjust the contrast, press Sel to select the command. The arrow cursor (>) will move to the right of the
colon (:) in Contrast: to indicate that the command submenu is selected. Press the q or p button until you're