NEC Express5800 Series Maintenance Manual page 67

Chapter 2 Convenient Features
If a network card equipped with four ports is installed in Slot 2, the screen as shown below is displayed.
For details about the options, see the table below.
Option
LAN1 Option ROM Scan
LAN2 Option ROM Scan
Mezzanine
Slot 1 Option ROM Scan
Slot 2 Port 1 Option ROM Scan
Slot 2 Port 2 Option ROM Scan
―
I/O Blade
See (b)I/O Blade submenu for this item.
This item is displayed when N8404-001F AD106a, N8404-003F AD106b, N8404-007F AD106c and
N8404-005F AT101b are installed.
Parameter
Disabled
[Enabled]
[Disabled]
Enabled
[Disabled]
Enabled
Note
For a RAID Controller, LAN card (network boot), or Fibre Channel controller, if no Hard
Disk Drive on which an OS is installed is connected, set the option ROM for that slot to
Disabled.
Express5800/B120e-h Maintenance Guide
Descriptions
Enable or disable the option ROM Scan for on-board LAN
1.
Enable or disable the option ROM Scan for on-board LAN
2.
Enable or disable the option ROM Scan on each
Mezzanine slot.
If a card that supports network boot is installed and this
option is set to Enabled, the available Boot Protocol is
displayed.
1. System BIOS
[ ]: Factory settings
67