NEC Express5800 Series Maintenance Manual page 145

Chapter 3 Appendix
BMC Message on Lower LCD Line
E-Keying inconsistency Error (Not
Power ON)
Location Error (Not Power ON)
Node Manager Firmware Image
execution Failed
Node Manager Firmware Flash
Erase Error
Node Manager Firmware Flash
Corrupted
Node Manager Internal Error
Node Manager can't communicate
BMC
Node Manager Manufacturing Error
Node Manager Persistent Storage
Integrity Error
Cause
In the Blade Enclosure,
combination of installation
locations of CPU blade,
mezzanine card, and switch
module is not correct. Thus, an
unconformity of interface signal
was detected and the CPU
blade failed to power on.
In the Blade Enclosure, the
installation location of CPU blade
is incorrect, or the installation
locations of the fan unit and CPU
blade are incorrect. Thus, the
CPU blade failed to power on.
Abnormality in Node Manager
occurred.
Express5800/B120e-h Maintenance Guide
Solution
Refer to the User's Guide of the Blade
Enclosure to make sure that the CPU blade
and switch module are installed in correct
locations. If this does not resolve the
problem, contact your sales representative.
Refer to the User's Guide of the Blade
Enclosure to make sure that the CPU blade
is installed in correct locations. Check if the
fan units and CPU blades are installed in
correct locations. If this does not resolve
the problem, contact your sales
representative.
Turn off the power, wait for about 30
seconds, and restart the server. If this does
not resolve the problem, contact your sales
representative.
1. POST Error Message
(2/2)
145