NEC Express5800 Series Maintenance Manual page 32

Chapter 1 Maintenance
EXPRESSBUILDER does not support this computer.
Insert EXPRESSBUILDER disc for the computer and click OK
to restart the computer.
Failed to get the hardware parameters on the motherboard.
Check if EXPRESSBUILDER is for this computer or if the
motherboard has failed.
Failed to find a file.
Failed to open a file.
Failed to get the parameters of a file.
Failed to save a file.
Failed to copy a file.
An undefined error occurred.
[?] Unable to start EXPRESSBUILDER from Internal Flash Memory
Did you press <F3> key to start EXPRESSBUILDER from Internal Flash Memory while POST was
being executed?
→
When the following message, "Press <F2> Setup, <F3> Internal Flash Memory, <F4> ROM
Utility, <F12> Network", appears on screen after starting up, press <F3> to start
EXPRESSBUILDER from Internal Flash Memory.
Is there a message, "<F3> Internal Flash Memory", displayed on the POST screen?
→
If not, make sure that Internal Flash Memory is connected correctly by referring to Chapter 2 (5.
Details of EXPRESSBUILDER).
32
Message
Express5800/B120e-h Maintenance Guide
5. Troubleshooting
Solution
Run the correct version of
EXPRESSBUILDER.
Contact your sales
representative.
EXPRESSBUILDER disc has
stains or cracks or the optical
disk drive is faulty.
Contact your sales
representative.
Contact your sales
representative.