DPS Telecom NetGuardian V16 G2 User Manual page 112

106
SNMP manager?
A. The control relays are operated by issuing the appropriate set commands, which are contained in
the DPS Telecom MIB.
Q. How can I associate descriptive information with a point for the RTU granular traps?
A. The NetGuardian alarm point descriptions are individually defined using the Web Browser.
Q. My SNMP traps aren't getting through. What should I try?
A. Try these three steps:
1. Make sure that the Trap Address (IP address of the SNMP manager) is defined. (If you changed
the Trap Address, make sure you saved the change to NVRAM and rebooted.)
2. Make sure all alarm points are configured to send SNMP traps.
3. Make sure the NetGuardian and the SNMP manager are both on the network. Use the unit's ping
command to ping the SNMP manager.