Table of Contents
Advertisement
S E T T I N G U P T H E M A C H I N E A N D C O M P U T E R T O W O R K T O G E T H E R
If you are using Windows
Computer. you may see "New Hardware Found Brother MFC-9870"
during startup.
You can select "Do not install a driver (Windows
again)." and click OK, so Windows
again
—OR—
If you see "Update Device Driver Wizard", Click Next to bypass the
®
Windows
Plug and Play Printer Driver screens, followed by Finish.
If you are using Windows
Wizard" during startup, follow the instructions from the installer, then
click Next. Click Finish when it appears on the screen.
Installing the Software/Drivers under
®
Windows
All the software and drivers are supplied on a single CD. An Auto-Install
program will guide you through most of the installation process.
1
Make sure that your machine is connected to your computer and that
the machine is switched on.
2
Turn your computer on and start Windows
3
Insert the CD-ROM into your CD-ROM Drive. Windows
95/98/NT4.0 will be detected automatically, and if possible the
Auto-Installer will run automatically. If the Auto-Installer does not
run after a few seconds, you can run it by:-
A) Click the START button and then select RUN from the
Start Menu.
B) Type X:\SETUP.EXE" [where X is your CD-ROM Drive] in
the command line box.
C) Click on OK.
YOU CAN EXIT FROM THE AUTO-INSTALLER AT ANY TIME BY
CLICKING ON THE ICON IN THE BOTTOM RIGHT HAND
CORNER OF YOUR SCREEN.
4
From the Auto-Installer Select your preferred language by double
clicking on it with your mouse.
5
The MFC-9870 is a parallel laser device so select this option, again
by double clicking.
6
Select STEP 1 and install the Brother Resource Manager. You can
either install the software now or make floppies*. Follow the
onscreen prompts and re-boot your PC when instructed to do so.
®
95, after you connect Brother MFC to a
®
will not display this dialog box
®
98, you may see the "Add New Hardware
®
®
will not prompt you
.
®
95
Advertisement
Table of Contents
