Specifying Video Qos Settings - JDS Uniphase HST-3000 User Manual

11 Select RTSP Port, and then enter the port number.
12 Select RTSP Vendor and then enter the RTSP Vendor.
The Video settings are specified.
Specifying
The following procedure describes how to specify the Video
QoS settings.
Video QoS
settings
To specify Video QoS settings
1 Press the VID QOS soft key. You may need to scroll left or
2 Press 1 then enter the Jitter Pass threshold, in msec.
3 Press 2 then enter the Jitter Fail threshold, in msec.
4 Press 3 then enter the Loss Rate Pass threshold, in
5 Press 4 then enter the Loss Rate Fail threshold, in
HST-3000 IP Video Testing User's Guide
This selection allows you to save results (as a .xml file)
on a timed interval and FTP each file. This is useful for
long term monitoring.
This is the port where RTSP signaling communication
takes place in a particular network.
This setting is only relevant in Terminate mode.
right to find it.
The Video QoS Settings screen appears.
percent.
percent.
Chapter 2 IP Video Testing
Video setup
21