Specifying Mpeg Qos Settings - JDS Uniphase HST-3000 User Manual

Chapter 2 IP Video Testing
Video setup
Specifying
MPEG QoS
settings
22
6 Press 5 then enter the Latency Pass threshold, in msec.
7 Press 6 then enter the Latency Fail threshold, in msec.
8 Press 7 then enter the Leave Latency Pass threshold, in
msec.
9 Press 8 then enter the Leave Latency Fail threshold, in
msec.
The video QoS settings are specified.
The following procedure describes how to specify the MPEG
settings.
To specify MPEG QoS settings
1 Press the MPEG QOS soft key. You may need to scroll
left or right to find it.
The MPEG QoS Settings screen appears.
2 Press 1 then enter the Error Indicator Pass threshold,
between 1 and 1000.
3 Press 2 then enter the Error Indicator Fail threshold,
between 1 and 1000.
This threshold controls the number of times the Error Indi-
cator bit can be set in the MPEG2-TS header before the
Error Ind. QoS is changed.
HST-3000 IP Video Testing User's Guide