Initializing The System - Sony SAT-HD300 Operating Instructions (primary manual) Operating Instructions Manual

8. CUSTOMIZATION

8-7. Initializing the System

Signal Strength
Depending on the Dish Type that is selected, the Signal Strength menu shows you up to three sig-
nal strength bars for Satellite Networks A, B, and C, in order to help you adjust the dish to the cor-
rect position with the elevation, azimuth, and tilt values obtained from the Your Location menu.
While the maximum signal strength is 100, there will be no apparent difference in picture quality
between signal strengths of 60 to 85. The higher the signal, the less likely you are to experience
picture quality degradation during adverse weather conditions such as heavy rain or snow.
A transponder is a receiver/transmitter on the satellite. It receives signals from DIRECTV and
retransmits them to your dish. The DIRECTV
strength of most transponders by using the following method.
To see the signal strength:
1. Press the MENU button on the Remote Control to display the on-screen menu.
2. Select the DIRECTV
3. Scroll down to Initial Setup menu using "
4. Move the highlight to the right with "
5. When the highlight is on the Signal Strength, press " ". The signal strength dialogue box will be
displayed.
6. Move the highlight to select the desired transponder and satellite.
7. Press " F
NOTE
Depending on your location in the United States, certain transpon-
ders may not be available. It is normal for the signal strength level of
a few transponders to be at zero.
75
® menu by pressing " " on the remote control.
" to return to previous menu.
® HD Receiver is capable of displaying the signal
".
E
G " to select Signal Strength.