Setting Default Signal Out - Sony SAT-HD300 Operating Instructions (primary manual) Operating Instructions Manual

8-10. Setting Default Signal Out

Output Channel
If you use the OUT TO TV jack, select channel 3 or 4 to send RF signal from your DIRECTV
HD Receiver to your TV. Your TV must be tuned to the selected channel to display the pic-
ture.
Loop Through
A signal from CABLE IN or ANT IN jacks is passed through to the OUT TO TV jack when
your HD receiver is in the standby (power off) mode.
To set Out to TV settings of the DIRECTV HD Receiver:
1. Press the MENU button on the Remote Control to display the on-screen menu.
2. Scroll down using "
3. Select the Setup menu by pressing " ".
4. Scroll down to Out To TV using "
5. Move the highlight to the right with "
6. Select your output channel to Channel 3 or Channel 4 by pressing "
Select your default signal source to Antenna or Cable by pressing "
7. Press the MENU button to return to the previous menu or press the EXIT button on the
remote control to return to TV viewing.
" on the remote control.
E
E ".
".
G
®
".
F G
".
F G
82