Programming The Remote Control - Sony SAT-HD300 Operating Instructions (primary manual) Operating Instructions Manual

4-3. Programming the Remote Control

The RM-Y822 remote control is a universal remote control that can be programmed to control
most TV, VCR, DVD and Amp models of the brands that appear on section 4-4.
1. Find the code(s) for the brand of the device you want to operate with this remote
control.
You can find these codes on section 4-4.
2. Press the CODE SET button.
The function indicator begins flashing. If you are setting codes for more than one VCR type,
move the device switch to either the AV1 or AV2 position.
3. Press the 0-9 buttons to input the brand code, then press the ENTER button.
The function indicator goes off, and the remote is set up to operate that device.
4. Test the remote control.
Press the POWER button for that equipment, then press other operation controls such as
the CH+/- buttons. If the device does not respond to the remote control, repeat from step 2
and enter a different brand code in step 3.
NOTE
See section 8-24 for instructions on selecting
IR or RF type control.
40