Setup And Connections - Sony SAT-HD300 Operating Instructions (primary manual) Operating Instructions Manual

3. SETUP AND CONNECTIONS

3-4. Connecting to Antennas - Oval Dish (Satellite A, B)
Antenna
Cable TV
wall jack
Receiving Signals
1. Connect the "Antenna" to the "ANT IN" jack on the DIRECTV
2. Connect the cable TV signal to the "CABLE IN" jack on the DIRECTV HD Receiver using a coaxial RF cable.
3. Connect the "Jack 1" of the multi-switch to the "SATELLITE IN" jack on the DIRECTV HD Receiver using
a coaxial RF cable. (For proper dish installation, refer to the "Installer's Guide" provided with your satellite
dish antenna.)
4. Connect the "Phone Wall Jack" to "PHONE JACK" on the DIRECTV HD Receiver using a phone cable.
NOTE
While you are subscribing to a DIRECTV
programming package, you can still view
over-the-air and cable TV programs, if you
make connections to the over-the-air and/or
cable jacks.
25
LNB
Sat A
VIDEO OUT
ANT IN
1 2
DIGITAL
AUDIO
S VIDEO
OUT
CABLE IN
OUT
L1 L2
OUT TO TV
R1 R2
OPTICAL
AUDIO OUT
®
LNB
Sat B
Dish
5x4 Multi-switch
Output
COMPONENT OUT
(1080i i /720p/480p/480i i )
DATA PORT
Y
RGB OUT DVI-HDTV OUT
Pb
TYPE
Pr
(1080i/720p/480p) (1080i/720p/480p) (1080i i /720p/480p/480i i )
Phone wall jack
® HD Receiver using a coaxial RF cable.
NOTE
A triple LNB multi-satellite dish with a SAT
C LNB is required to receive all DIRECTV
High-Definition programming, along with
this DIRECTV HD Receiver.
RF SATELLITE
REMOTE PHONE IN
JACK
VCR
CONTROL
®