Programming The Remote Control - Sony CABLEVISION DHG-B45CV Hardware Setup Instructions

Programming the
Remote Control
Button Description
FULL TV Displays a full screen display of the last channel.
Arrows (G g F f) Moves the highlight within menus and guides.
OK Selects the highlighted item.
BACK
Displays the previous screen
FWD Displays the next screen.
LAST CH
Toggles between the last and current channel.
DISPLAY Displays the Title Bar (see the Cablevision user guide for
details).
VOL +/-
Adjusts the volume.
CH +/- Changes the channel.
CODE SET
Used for programming the remote control to operate
non-Sony video equipment. For details, see
"Programming the Remote Control" on page 5.
The remote control is preset at the factory to operate any Sony brand
TV and VCR. If you have any other brand of TV or VCR, use the
following procedures to program the remote to use the highlighted
buttons shown on pages 4 and 5.
To program the remote
1
Turn to "Remote Control Programmable Codes" on page 7, and
find the 3-digit code for your TV or VCR. If more than one code is
listed, use the number listed first to complete the following
procedures.
2
Press the
CODE SET
3
Enter the 3-digit code using the 0-9 buttons.
4
Press the button (located below the "
#
To check if the code works
1
Aim the remote control at the component you just programmed
(e.g. aim at the TV and press
2
If the component responds, try the
component responds, you're done.
Using the Remote Control (RM-Y806)
.
button.
9
).
TV POWER
and
CH+
" button).
buttons. If the
CH-
5