Scanning Conditions - Casio DT-X100 Series Software Manual

Scanning conditions

2.9.3
Conditions can be specified for scanning symbols.
(1) Specifying symbols which are valid for scanning
Types of symbols can be specified as valid or invalid for scanning. If only specific symbols are to be
scanned, set "Enable" for scanning on those symbols only, to reduce scan processing time.
Default setting
:
(2) Specifying readable digits
The minimum and maximum permitted numbers of digits for each symbol can be specified. If only
symbols with a specific number of digits is to be scanned, specify the necessary digit number to lower
the error rate.
Refer to "2.10.1 Barcode scan specification" for the minimum and maximum numbers of scanned
digits.
(3) Specifying check character calculation and output
Check character calculation can be set to enabled or disabled for some symbols.
It is also possible to specify whether the check character should be added to the scanned text string.
Refer to check characters and check character output in "2.10.1 Barcode scan specification" for how
to disable or enable calculation and output of check characters for each symbol type.
All invalid
61