Scan Result Notification - Casio DT-X100 Series Software Manual

Control character conversion example
The example of conversion after barcode data scanning is as shown below.
Control character conversion example
OBRDRV_R.ini
[ConvSrc]
Code01=0x1D
Code02=0x0A
[ConvDst]
Char01='/'
Char02='@'
[Delete]
Code01=0x02
Code02=0x03
2.8.5

Scan result notification

When scanning a barcode is complete, a notification about the scanning result is received by the
user via either LED, buzzer, or vibrator. Each notification method can be set to "Enable" or
"Disable".
Table 22-22
LED
Buzzer
Vibrator
*1 Scan failure
Scanning will fail when one of the following occurs.
 When a barcode with a number of digits outside the specified range is scanned
 When a check digit calculation error occurs
 Full ASCII conversion error occurs in scanning bar code of Code39 symbology or Code128
symbology.
The LED did not light for a scan failure.
Barcode data before conversion
01230x0A45670x1D890x0201
(Underlined portion is represents
the control character)
Configuration Scan
successful
Valid On in green
Disabled None
Valid Scanning
complete
sound
Disabled None
Valid Vibrates
Disabled None
Barcode data after conversion
0123@4567/8901
- 0x0A is replaced by '@', and
0x1D by '/'.
- 0x02 is deleted.
Scan Scanning
*1
Failure interrupted
(Trigger key
released)
None None
None None
None None
None None
None None
None None
53
OBR buffer Default
*2
overrun
On in green Valid
None
Warning sound Valid
None
None Disabled
None